We configure fail-safe fiber optic rings, redundant industrial gateways, and intrusion prevention systems specifically for energy utility facilities. Your control network stays online and protected.
Substation hardened
50 ms failover
Ready for NERC CIP audit?
Our engineering team deploys redundant fiber rings, hardened industrial gateways, and protocol-aware intrusion prevention systems specifically for SCADA and PLC control networks in power generation and distribution facilities.
Self-healing dual-path fiber backbone with automatic failover under 50 milliseconds. Supports IEC 61850 and DNP3 protocols for substation and control center communication. Eliminates single points of failure in your industrial network.
Retrofits existing PLC and RTU networks with stateful firewall, deep packet inspection, and anomaly detection tailored for Modbus and Profinet traffic. Integrates with your existing SCADA without operational downtime.
Monitors all traffic between field devices and control servers using signature-based and behavioral analysis. Automatically blocks malicious packets without affecting legitimate operations. Certified for NERC CIP and IEC 62443 environments.
Deploys industrial-grade firewalls and VLANs to isolate control system traffic from corporate IT networks. Enforces strict access control policies between zones based on Purdue model architecture.
Provides multi-factor authenticated VPN tunnels with session recording and command logging for remote PLC programming and diagnostics. Prevents unauthorized access while enabling remote troubleshooting.
Why energy utilities trust our network security
Our fiber optic ring topology uses dual-path redundancy. If a line breaks or a switch fails, traffic reroutes in under 50 milliseconds — no dropped packets, no SCADA timeouts. This is not a theoretical SLA; it’s a measured behavior verified during commissioning at a 220 kV substation.
We harden existing RS-232 and Ethernet gateways with stateful firewalling and deep packet inspection for Modbus and Profinet. No rip-and-replace. The suite installs without downtime and reduces the attack surface of aging RTUs by blocking unauthorized write commands and malformed frames.
Our IPS uses signature-based and behavioral analysis tuned for ICS protocols. It detects zero-day exploits and protocol anomalies while automatically allowing normal control commands. The system is certified for NERC CIP and IEC 62443 environments and has been deployed in three regional transmission organizations.
Explore our core products designed to secure SCADA and PLC control environments in energy utilities.